Publicité
SYMBOLS USED IN THE MANUAL ..........................................................10
ENVIRONMENT PROTECTION .................................................................10
TECHNICAL DATA TABLE KEY ................................................................10
COMPLIANT USE.......................................................................................10
PARTS OF THE APPLIANCE.....................................................................10
INITIAL OPERATION OF THE APPLIANCE ..............................................10
EMPTYING THE COLLECTION TANK ......................................................11
MAINTENANCE ..........................................................................................11
TROUBLESHOOTING ............................................................................... 11
EC DECLARATION OF CONFORMITY .....................................................24
TECHNICAL DATA .....................................................................................25
SYMBOLS USED IN THE MANUAL
Open book symbol with an "i":
Open book symbol:
Covered place symbol:
Symbol i:
ENVIRONMENT PROTECTION
TECHNICAL DATA TABLE KEY
COMPLIANT USE
WARNING:
•
•
This appliance is suitable for commercial, professional and industrial use, such as workshops,
industries, schools and hotels.
•
The ambient temperature must not exceed 40° C.
PARTS OF THE APPLIANCE
1. Vacuum head.
2. Handle bar for vacuum head lifting.
Vacuum motor control switch.
4. Power cable.
5. Power cable plug.
6. Power cable support.
7.
8.
9.
10.
11. Vacuum cap fastening hook.
12. Collection tank.
Nozzle.
14. Vacuum hose release button .
15. Handle.
16. Collection tank support trolley.
17. Pivoting wheel.
18. Rear wheel.
19. Trolley control handlebars .
INITIAL OPERATION OF THE APPLIANCE
1.
N.B.
2. Open the outer box.
Remove the accessories from the box and carefully lay them on the ground.
4. Remove the appliance from the packaging.
N.B.:
CAUTION
DANGER
5. Insert the vacuum hose into the nozzle on the collection tank, press the button on the nozzle and
insert the vacuum hose fully (Fig.05).
6. Connect the extension pipe to the vacuum hose.
7. Choose the most suitable attachment for the work to be carried out and connect it to the
extension pipe.
Dry cleaning
1.
Fig.04).
2. Check that the plug on the power cable is connected to the power supply socket, otherwise
disconnect it.
WARNING:
Free the vacuum head (Fig.06
N.B.:
N.B:
4. Secure the vacuum head to the collection tank (Fig.09-10).
5. Plug the power cable into the mains socket.
ATTENTION:
6. Switch on the appliance by positioning the vacuum motor switch to position "I" (Fig. 4).
N.B.:
7. Start work.
If the "combined nozzle" accessory is used, set the switch in the brush to "HARD SURFACE" or else
"CARPET FLOORS". Proceed with the vacuuming.
N.B:
ATTENTION:
If when working a reduction in the vacuuming power is noted or the noise of the appliance becomes
•
•
Remove the plug from the power socket.
WARNING:
10
Fig.08).
Fig. 04).
Publicité
