GE GTE21 Manuel D'utilisation Et Instructions D'installation page 10

Care and Cleaning
Moving the Refrigerator
Be careful when moving the refrigerator away from
the wall. All types of floor coverings can be damaged,
particularly cushioned coverings and those with
embossed surfaces.
Turn the leveling legs at each front corner of the
refrigerator counterclockwise until the rollers support the
refrigerator. Pull the refrigerator straight out and return it
to position by pushing it straight in.
Moving the refrigerator in a side direction may result in
damage to the floor covering or refrigerator.
Preparing for Vacation
unplug the refrigerator. Move the refrigerator control to
soda solution of one tablespoon (15 ml) of baking soda
to one quart (1 liter) of water. Leave the doors open.
Preparing to Move
Secure all loose items such as grille, shelves and
drawers by taping them securely in place to prevent
damage. To prevent the doors from opening while
moving, secure them to the case with tape.
Replacing the Light Bulb
power to the light circuit.
2. Remove the top shelf (if necessary).
3. The bulb is located behind a light lens in the ceiling
of the refrigerator section. Remove the light lens
by removing the single screw using a Phillips head
screwdriver.
4. Replace the bulb with an appliance bulb of the same
or lower wattage.
5. Replace the light lens.
6. Plug the refrigerator back in.
10
WARNING
ELECTRICAL SHOCK HAZARD
When pushing the refrigerator back, make sure you
don't roll over the power cord or icemaker supply line
(on some models).
After rolling the refrigerator back into place, turn the legs
clockwise until the legs again bear the weight of the
refrigerator.
shut off the water supply to the refrigerator.
qualified servicer drain the water supply system (on
some models) to prevent serious property damage due
to flooding.
Be sure the refrigerator stays in an upright position
during moving.
Screw
49-1000636 Rev.2