Franke FTU PLUS 3707 XS Manuel D'utilisation page 7

1. SAFETY
EN
INFORMATION
For your safety and correct
operation of the appliance,
read this manual carefully
before installation and use.
Always keep these instructions
with the appliance even if you
move or sell it. Users must fully
know the operation and safety
features of the appliance.
The wire connection has to
be done by specialized
technician.
• The manufacturer will not be
held liable for any damages
resulting from incorrect or
improper installation.
• The minimum safety distance
between the cooker top and
the extractor hood is 650 mm
(some models can be installed
at a lower height, please refer
to the paragraphs on working
dimensions and installation).
• If the instructions for installation
of the gas hob specify a
greater distance, this must be
respected.
• Check that the mains voltage
corresponds to that indicated
on the rating plate fixed to the
inside of the hood.
• Means for disconnection must
be incorporated in the fixed
wiring in accordance with the
wiring rules.
• For Class I appliances, check
that the domestic power supply
All manuals and user guides at all-guides.com
guarantees adequate earthing.
• Connect the extractor to the
exhaust flue through a pipe of
minimum diameter 120 mm.
The route of the flue must be
as short as possible.
• Regulations concerning the
discharge of air have to be
fulfilled.
• Do not connect the extractor
hood to exhaust ducts carrying
combustion fumes (boilers,
fireplaces, etc.).
• If the extractor is used in
conjunction with non-electrical
appliances (e.g. gas burning
appliances), a sufficient degree
of aeration must be guaranteed
in the room in order to prevent
the backflow of exhaust gas.
When the cooker hood is used
in conjunction with appliances
supplied with energy other than
electric, the negative pressure
in the room must not exceed
0,04 mbar to prevent fumes
being drawn back into the room
by the cooker hood.
• The air must not be discharged
into a flue that is used for
exhausting fumes from
appliances burning gas or
other fuels.
• If the supply cord is damaged,
it must be replaced from the
manufacturer or its service
agent.
• Connect the plug to a socket
complying with current
regulations, located in an
7