Publicité
Problem
Spots on stainless steel or sil-
ver.
Spots or films on the dishes.
Possible causes
Incorrect detergent dosage.
Old detergent. Detergent is a
perishable product.
Dishes loaded incorrectly.
Glasses and cups have toppled
over during the program.
The filters are clogged.
The filters are not fitted cor-
rectly.
Drainage pump stop missing.
Some foodstuffs, such as mus-
tard, mayonnaise, lemon, vineg-
ar, salt and dressings, can
cause spots on stainless steel
if left for too long.
All stainless steel can cause
spots on silver if they come into
contact during dishwashing.
Aluminium can also cause spots
on dishes.
Incorrect rinse aid dosage set-
ting.
The setting TAB is activated and
all-in-one detergent with insuffi-
cient drying effect is being used.
Salt compartment empty.
Incorrect water softener setting.
Action
Dose according to water hard-
ness. Far too much or far too
little detergent results in poorer
dishwashing results.
Avoid large packages.
Do not cover porcelain with
large bowls or the like. Avoid
placing very tall glasses in the
corners of the baskets. See the
chapter Loading the dishwash-
er.
Place dishes to sit steady.
Clean the coarse and fine filters.
Check that the filters are fitted
correctly. See the chapter Care
and cleaning.
Check that the yellow drainage
pump stop (on the right in the
bottom drain) is in place. See
the chapter Care and cleaning.
Rinse off these types of food-
stuffs if not starting the dish-
washer immediately. Consider
using 1h 65° with the Speed
wash option.
In order to avoid marks and tar-
nishing, separate dishes made
from different metals, such as
silver, stainless steel and alu-
minium.
See the chapter Settings.
Switch all-in-one detergents or
deactivate the TAB setting and
top up with salt and separate
rinse aid. See Rinse aid in the
chapter Settings.
Top up with salt. See the
chapter Before washing for the
first time.
See Water hardness in the
chapter Settings.
29
Publicité
