Publicité
Have any repair and maintenance work
o
that is not described in these instructions
carried out by our Service Centre (see
"Service"). Only use original replacement
parts.
˜ Cleaning
WARNING! Risk of electric shock!
m
Never spray down the product with
u
water.
m
NOTICE! Risk of damage to the
product!
Chemical substances may attack the
u
plastic parts of the product. Do not use
any cleaning agents or solvents.
Keep the ventilation slots, motor housing,
o
front handle
and handle
[
4 ]
a damp cloth or brush to do this.
Cleaning and care of the safety cutter
bar
[
2 ]
Tools and aids required:
o
–
Cloth
–
Care oil spray
Care after each use:
o
–
Remove any green cuttings that are stuck.
–
Clean the safety cutter bar
oily cloth.
–
Maintain the safety cutter bar
care oil spray.
˜ Care and repair
Before each use: Check the product for
o
obvious defects such as loose, worn or
damaged parts. Ensure that the screws in
the safety cutter bar
Check the stop protection
o
cutter bar
and hand protection
2 ]
[
damage and correct fit. Replace these parts
if necessary or have them repaired by our
Service Centre (see "Service").
42 GB/IE
clean. Use
[
8 ]
with an
[
2 ]
with a
2 ]
[
are firmly in place.
2 ]
[
, safety
[
1 ]
for
3 ]
[
You can smooth out slight nicks on the
o
cutting teeth yourself. To do this, sharpen
the cutting edges with an oil stone. Only
sharp cutting teeth provide a good cutting
performance.
A blunt, bent or damaged safety cutter
o
bar
must be replaced.
[
2 ]
Have any work that is not described in this
o
user manual performed by our Service
Centre (see "Service"). Only use original
parts.
˜ Storage
Always store the product
o
–
clean,
–
dry,
–
protected against dust,
–
in the blade encasing
–
out of the reach of children.
The storage temperature for the battery
o
packs
and the product is between 0 °C
[
9 ]
and +45 °C. Avoid extreme cold or heat
during storage to ensure the output of the
battery packs is not adversely affected.
Before storage: Remove the battery
o
packs
from the product.
9 ]
[
˜ Maintenance
˜ Replacing the hand
protection
(Fig. C)
Tools and aids required:
o
–
Hand protection
parts/Accessories")
–
Phillips screwdriver (not included)
1. Loosen the 2 screws
protection
with a Phillips screwdriver.
3 ]
[
2. Remove the damaged hand protection
3. Fasten the new hand protection
2 screws
.
[
]
,
[
]
(see "Replacement
3 ]
[
on the hand
[
]
3 ]
[
with the
3 ]
[
.
Publicité
