Publicité
˜ Charging the battery pack
m
NOTICE! Risk of damage to the
battery pack
Do not expose the battery pack
u
direct sunlight for long periods and do
not place it on a radiator. Observe an
ambient temperature of max. +50 °C.
NOTE
You can find detailed instructions in the
u
user manual of the charger
If the battery pack
u
it to cool down before charging.
1. Remove the battery pack
product.
2. Push the battery pack
slot of the charger
3. Connect the charger
4. After charging: Disconnect the charger
from the socket-outlet.
5. Pull the battery pack
charger
.
[
]
Control LEDs on the charger
Green
Red
Lights up
—
—
Lights up
—
Flashes
Flashes
Flashes
!
9 ]
[
to
[
9 ]
.
[
]
is still warm, allow
[
9 ]
from the
[
9 ]
into the charging
9 ]
[
.
[
]
to a socket-outlet.
[
]
[
out of the
9 ]
[
[
]
Meaning
Fully charged
Stand-by mode (no
battery pack
9 ]
[
inserted)
Charging
Battery pack
is
9 ]
[
overheated
Battery pack
is
[
9 ]
defective
˜ Operation
˜ Working with the product
m
WARNING! Risk of injury!
Pay attention to the following instructions.
u
m
NOTICE! Risk of damage to the
safety cutter bar
While cutting, make sure that you do not
u
touch any objects, such as wire fences or
plant supports.
Always wear sturdy shoes, long trousers,
ear protection, work gloves and protective
goggles when operating the product.
The product is only intended for work where
you are standing on the ground and not on
a ladder or other unstable surface.
Do not use the product if the on/off
switch
or the safety switch
7 ]
[
damaged.
]
If the safety cutter bar
with solid objects, switch the product
off immediately and remove the battery
packs
. Only then should you remove the
[
9 ]
object.
Avoid over-stressing the product while
working.
˜ Cutting techniques
Cut out thick branches in advance using
o
lopping shears.
The double-sided safety cutter bar
o
enables trimming in both directions, or via
pendulum movements from one side to the
other.
When cutting vertically, move the product in
o
a steady forward motion, or up and down
in an arch-shaped motion.
When cutting horizontally, move the
o
product in a sickle-shaped motion to the
edge of the hedge so that cut branches fall
to the ground.
Tie cords to achieve long, straight lines.
o
!
2 ]
[
is
[
]
becomes jammed
2 ]
[
2 ]
[
GB/IE
39
Publicité
