General Characteristics - Cembre B35M-TC025 Notice D'utilisation Et Entretien

ENGLISH
BATTERY OPERATED HYDRAULIC CUTTING TOOL
• Wear eye protection. Metal chips can fl y from blades when cutting.
• Do not cut short, free pieces of steel rod or rope as they may fl y off dangerously, causing
injury to the operator or persons nearby.
• Inspect the blades before each use. Do not use damaged blades.
• Damaged blades can break and cause injury or damage to the tool.
• Work in a clean, uncluttered area. Keep persons away from immediate work area.
• Use this cutting tool for the manufacturer's intended purpose only.
• Do not cut live cables or conductors.

1. GENERAL CHARACTERISTICS

TOOL TYPE:
Application range:
Rated operating pressure
Dimensions LxWxH
Weight with battery
Motor
Battery type CB1820L
Recommended oil:
Safety:
Operating temperature
Battery charger ASC30-36
Input
Acoustic Noise (Directive 2006/42/EC, annexe 1, point 1.7.4.2 letter u)
– The weighted continuous acoustic pressure level equivalent
A at the work place L
– The maximum value of the weighted acoustic displacement
pressure C at the work place L
– The acoustic power level emitted by the machine
L is equal to ...................................................................................................................................................... 69,3 dB (A)
WA
Risks due to vibration (Directive 2006/42/EC, annexe 1, point 2.2.1.1)
Tests carried out in compliance with the indications contained in UNI ENV 25349 and UNI EN 28662 part
1 st Standards, and under operating conditions much more severe than those normally found, certify that
the weighted root mean square in frequency of the acceleration the upper limbs are exposed to for
each biodynamic reference axis is 0,527 m/sec
WARNING
B35M-TC025
bar (psi):
mm (inches):
kg (lbs):
Volt DC:
Volt / Ah:
°C (°F):
27044000
Volt / Hz:
W:
is equal to .............................................................................................................. 64,9 dB (A)
pA
is equal to ........................................................................................ 99,7 dB (C)
pCPeak
B35M-TC025E B35M-TC025T B35M-TC025A
suitable for cutting steel ropes,
copper and aluminium conductors
450 (6,500)
391 x 133 x 81 (15.4 x 5.2 x 3.2)
3,1 (6.8)
18 / 2.0 Li-Ion
AGIP ARNICA 22 or ESSO INVAROL EP22 or equivalent
the tool is equipped with a maximum pressure valve
-15 to +50 (+5 to +122)
UE UK
27045000
220 - 240 / 50 - 60
2 max.
18
AUS/NZ USA/CAN
27047000 27046000
115 / 60
85
4