Publicité
User's Guide
3.1 Inputs and outputs
For detailed specification information, please refer to the specification table in the
Front panel
3
4
5
Oscilloscope analog inputs – BNC(f)
1
Detects readout pin on 10:1 attenuated probes such as P2036, P2056 and P2156Z.
Air vents for cooling fan. Do not block when oscilloscope is in use. Note presence of vents on side of
2
oscilloscope, in addition to front panel.
Probe compensation output. 1 kHz square wave. See probe User's Guide for compensation instructions.
3
Probe compensation ground
4
5
Power ( ) and status/trigger ( ) LEDs
Digital interface ports, compatible with TA369 MSO pods (sold separately). Refer to MSO pod user's guide.
6
Intelligent probe interface on Channels A to D of PicoScope 6400E models and Channels C to F of PicoScope 6800E
[4]
models.
Rear panel
Aux trigger input. Allows you to trigger the scope, or arbitrary waveform generator, from an external source.
7
Air vent for cooling fan. Do not block when oscilloscope is in use.
8
Arbitrary waveform generator (AWG) output – BNC(f). Do not apply an external voltage to this output.
9
10 MHz clock reference input – BNC(f)
10
USB 3.0 Type-B socket
11
12 V DC input. Use only the power adaptor provided.
12
Ground terminal. Accepts bare wire or 4 mm (banana) plug.
13
DO338-9
1
. See maximum input voltage marked on front panel of oscilloscope.
[4]
7
9
10
Copyright © 2020–2024 Pico Technology Ltd. All right reserved.
2
3
6
4
5
8
11
12
13
PicoScope 6000E Series oscilloscopes
PicoScope 6000E Series Data Sheet.
1
2
6
9
Publicité
