Loaded Lift And Fast Stroke - Jung JH 10 G-plus EX Mode D'emploi

NOTE
When laterally lifting a load, make sure that the toe
is not loaded on only one side. This could otherwise
damage the toe and bracket.
NOTE
Transport must only be carried out on a level, clean
and load-bearing surface. If you use a towing vehicle,
do not exceed the permissible trailing load and observe
the maximum braking force of the towing vehicle. Do
not exceed the transport speed of 2 km/h.
- 58 -

4.4.1 Loaded lift and fast stroke

1
The jacks JH 15 G plus and JH 20 G plus develop an
especially high lifting force. Only a small amount of
force is required. The load is only lifted slowly with
each pump movement.
> Load lift: Stick the pump lever into the load-lift
pump linkage (1) and lift the load.
> Rapid lift: Installed for lifting distances without load.
Stick the pump lever in the rapid-lift pump linkage (2)
and lift up the lifting toe until this touches the
bottom side of the load, then change to load-lift.
> Lower load: Carefully open the lowering screw (3).
© JUNG Hebe- und Transporttechnik GmbH
Jacks of the JH / JH EX / JHS series
2
3