T EC HN I C A L I N FO RMATIO N
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
I NSTALL ATI ON CO N SIDE R ATION S
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
⁄ Inspect this product thoroughly before installation.
Claims for shipping damage made after installation
will not be honored.
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ The thermostatic cartridge and shutoff cartridges are
included with the trim kit.
⁄ This valve is for one shower function plus a hand-
shower. It is for use with rough valve 45442181 (not
included).
⁄ Protection against backflow is provided by check
valves.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.75 GPM (6.6 L/min)
E N G L I S H
⁄ The thermostatic mixer is for use with shower heads
rated at 1.1 GPM (4.2 L/min) or higher.
⁄ The valve can support a maximum of 24 lbs. (11 kg.)
⁄ Prolonged exposure to residue from soap, shampoo,
other toiletries, or cleaning agents can damage
the finish. Such damage is not covered under the
Hansgrohe warranty.
⁄ To prevent scald injury, the maximum output tempera-
ture of the shower mixing valve (not included) must
be no higher than 120°F (49°C). In Massachusetts,
the maximum output temperature can be no higher
than 112°F (44°C).
⁄ Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.