After Use; Maintenance; Troubleshooting - Lavorwash GV EGON VAC Mode D'emploi

Every time you finish working with the applian-
ce, switch it off, unplug it and wind the electric
cable into its cable rewinder (A).
Empty the tank (M) every time you finish
using it (see section "11. EMPTYING THE TANK").
Clean the outside of the appliance with a damp
cloth.
Do not use solvents or detergents.
Solvents could damage the plastic parts of the
appliance.
Do not steam-clean the appliance.
Empty the tank every time you finish using it
(see section "11. EMPTYING THE TANK").
We recommend using Cleansy decalcifier (20):
its regular use avoids the formation of hard
water deposits inside the boiler. Use the pro-
duct according to its instructions for use shown
on the label.
Clean the soleplate of the iron while it is warm
(use special products available on the market).
Only use water to clean the attachments.
To eliminate dirty residues from the inside of
the attachments (extension tubes or brushes);
wash the internal vacuuming ducts with run-
CAUTION! Repairs should be carried out only
by an authorised Service Centre.
Breakdowns may occur when the appliance is
not used properly.
The following table describes a few problems
EN

13 AFTER USE

14 MAINTENANCE

15 TROUBLESHOOTING

Let the appliance and the iron cool down before
putting them away.
ning water.
CAUTION! Do not wash or immerge the flex
(1) in water or any other liquid.
To prevent the brushes from becoming missha-
pen, leave the clean brushes to dry with the
bristles facing upwards.
The appliance is supplied with a kit of spare
seals. Periodically, check if the seals worn out
and, if necessary, replace them.
REPLACEMENT OF FILTERS:
micro-fiber filter: best to replace every 6
months
sponge filter: best to replace every 6 months
air-filter: best to replace every year
motor-carbon filter: best to replace every year
and explains how to solve them. If our solutions
do not help, call an authorised Service Centre.
18