Ironing; Using The Appliance For Ironing - Lavorwash GV EGON VAC Mode D'emploi

Using the appliance for ironing

10.1
Plug the power cable (B) into the socket. Lift the safety cover (V).
Plug the iron plug (31) into the socket (W)
flex (1) is inserted, first remove the quick connector (24) of the
flex by pressing the front button (25).
Please refer to the chapter "6.2 Starting up the boiler" before use.
Press the main switch (D) and the boiler switch (E); the boiler
switch pilot light (I) will come on. Now the water will be heated
to create the steam.
Pre-select the required steam power by using the steam
adjustment knob (J) on the appliance.
The gauge (K) indicates the level of pressure inside the boiler;
The grey/silver area indicates the ideal pressure for use.
Adjust the required temperature with the knob located on the
iron (34).
(picture 42)
The luminous button (33) will indicate that the soleplate of the
iron is heating up.
(picture 43)
The iron will be ready for use when the luminous button (33)
turns off.
Adjust the amount of steam with the knob (J) located on the
appliance.
To work with steam, set a temperature higher than the steam
symbol indicated on the knob (34).
When the steam-ready pilot light (F) comes on, the appliance
will be ready to function with steam.
Press the iron steam lever button (33) to make steam come out.
(picture 44)
WARNING: The appliance can be equipped with different
types of irons, depending on the supplied equipment or
specifications.
CAUTION!
• Before connecting the iron, switch off the appliance and
unplug the power cable (B).
• Always remove the plug from the socket before connecting
the iron.
• The steam hose (32) must not come in contact with the
soleplate of the iron, knifelike objects or sharp corners.
• Place the iron only on its support (18).
• Do not leave the iron unattended when connected to the
appliance.
EN

10 IRONING

. If the
(picture 40-41)
(picture 43)
(picture 45)
picture 40
picture 41
picture 42
picture 43
picture 44
picture 45
15