Starting Up; Preparing The Vacuum Cleaner; Replacing The Filter - Lavorwash GV EGON VAC Mode D'emploi

Preparing the vacuum cleaner

6.1
The appliance is supplied and equipped with a microfibre filter (P) which is
already assembled.
WARNING: For safety reasons, the handgrip (T) can be released only if
the quick connector (24) is not inserted.
• Lift the safety cover (V)
• Lift the quick connector (24) of the flex by pressing the front button (25)
into the steam socket (W)
• Make sure it is properly fastened: button (25) should return to its initial
position; once in position it should click.
• Plug the power cable (B) into an appropriate socket provided with an
earthing system.
• Press the main switch (D); the pilot light (H) will come on.
Starting up the boiler
6.2
CAUTION!
When preparing the appliance for use, switch it off and unplug it.
WARNING:
The appliance must be placed on a horizontal flat surface.
• Remove the boiler water tank cap (C)
• Fill the boiler tank (max1.2 litres) using the recharging automatic valve bot-
tle (19a)
(picture 5)
is completely filled.
• Put on the boiler water tank cap (C)

Replacing the filter

6.3
• Press the two buttons (U) located besides the handgrip (T) down
completely
(picture 7)
• Lift up the handgrip (T)
• Lift up the handle (N) and remove the tank (M)
• Turn the tank handle (N) over and pull the filter
assembly with float (O) up/forward
• Replace the filter (P) or (Q) in its container
• Fit the lower filter cover (S) completely
EN

6 STARTING UP

(picture 2)
(picture 3)
(picture 4)
which stops the water supply when the boiler water tank
(picture 6).
(picture 9)
picture 7
(picture 8)
(picture 10)
picture 8
picture 1
picture 2
picture 3
picture 4
picture 5
picture 6
7