Publicité
ASSEMBLY
Assembly
1. Battery Charging
Only use the charger supplied in the delivery package. This is the only charger suited to the Li ion battery used in your screwdriver.
Note: The battery 7 is partially charged when delivered. Fully charge the battery 7 in the charger before using it for the first time to ensure it delivers optimum performance.
The Li ion battery 7 is protected against complete discharge during use. The speedE is switched off by a protection circuit if the battery 7 is low: The electric assisted screw-
driving no longer works and the speedE can now only be used as a normal screwdriver.
2. Fitting/replacing the battery
Open the end cap 8 by twisting in an anti-clockwise direction. To change the battery, remove the empty battery 7 from the screwdriver handle 6 . Then insert the charged
battery 7 into the screwdriver handle 6 . Ensure the battery 7 pole terminals are in the right position („-" in the end cap 8 ). Replace the end cap 8 on the speedE, turning
it in a clockwise direction.
Note: If the light 4 flashes, it indicates that the speedE battery is low (<20%). The electric assisted screw-driving will still work when the charge level is at 20%. If the charge
level continues to fall, only the light 4 will work to indicate that the battery 7 is empty.
3. Inserting the bit holder and bit
Insert the Wiha bit holder 1 into the correct position in the speedE's bit chuck 3 . Insert the Wiha bit 2 into the correct position in the bit holder 1 . The bit is held in the bit
holder 1 by a magnet.
4. Changing the bit holder and bit
Pull out the Wiha bit holder 1 or the Wiha bit 2 to remove. Since neither the Wiha bit holder 1 or the Wiha bit 2 are locked separately, they can be removed easily by pulling
against the holding/magnetic force.
Note: Do not use the supplied Wiha bit holder and Wiha bits to work on live electrical cable or wires.
Noise/Vibration Information
Sound emission values determined according to EN 62841. Typically the A-weighted sound pressure level of the product is 70 dB(A). Uncertainty K=3 dB.
The noise level when working can exceed 80 dB(A). Wear hearing protection! Vibration total values ah (triax vector sum) and uncertainty K determined according to EN 62841.
Drilling into metal: ah<2.5 m/s², K =1.5 m/s² Screwdriving without impact: ah<2.5 m/s², K =1.5 m/s². The vibration level given in this information sheet has been
measured in accordance with a standardised test given in EN 62841 and may be used to compare one tool with another. It may be used for a preliminary assessment of
exposure. The declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications, with different accessories or
insertion tools or is poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period.
An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job.
This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as:
maintain the tool and the accessories, keep the hands warm, organisation of work patterns.
14
Publicité
