Troubleshooting; Technical Specifications - asecos PURIFIAIR.488 Manuel D'utilisation

5. TROUBLESHOOTING

Error
Can not be switched on
(Power light not illuminated)
Can not be switched on
(Power light flashing)
Power button does not react
The air is dirty, but the display
light is continuously illuminated
"green".
The air contamination indicator
light remains "red" even while
the device is running consis-
tently.
There are crackling noises while
the device is in operation
The purified air smells bad
The air purifier does not
automatically switch to Sleep
mode at night.

6. TECHNICAL SPECIFICATIONS

Model
Nominal voltage
Rated frequency
Rated power (5 level)
Noise level (5 settings)
Quantity of purified air (CADR)
Suggested filter replacement interval
Net weight
Product dimensions (W x D x H)
20
Common malfunctions, description of error codes and correction methods
Measurement
Check to ensure the plug is inserted correctly into the outlet.
Check to ensure the covers are fitted correctly on the air intake ducts.
Check to ensure the air outlet cover on the top of the device is inserted straight and correctly.
Check to ensure the device set-up location fulfils the requirements, and that the contaminated air can easily
be suctioned by the device. Set up in another location if required.
Check whether the particle sensor is contaminated, and clean it if necessary.
Open the air intake cover on the top of the device and remove any dust particles.
Check whether the filter is contaminated or has not been replaced in a long time. Clean and replace the filter
regularly.
Check whether Automatic mode is turned on. Switch to Automatic mode if necessary.
PURIFIAIR.488
AC 220~240 V
50/60 Hz
Sleep mode 10 W – turbo mode 85 W
≤38,0 dB(A)
488 m³/h
Plastic mesh pre-filter: every 2 years
Multi-component filter units: every 6 months
11,3 kg
400 × 230 × 640 mm