Publicité
EN
Description of main parts
Assembly instructions
Fig. 1
Gear case
Bolt x3
Engine
Clutch shoe
2. Throttle wire engine-to-gear case connection (Fig.2)
(1) Work open the connector case using a slotted screwdriver at point A, and remove the case.
(2) Connect the throttle wire end on the engine side to its counterpart on the gear case side.
(3) Reattach the connector case.
(4) Close the case securely.
Connector case
A
3
Gear case
Handle
Throttle lever
*
Throttle wire (gear case side)
Connector case
WWW.NIKOLAOUTOOLS.COM
Drill
1. Gear case-to-engine (Fig. 1)
(1) Lay the engine on the ground with the clutch shoe facing upwards.
Screw the stud into the * marked hole (1 spot only).
(2) Set the gear case on the engine and loosely tighten the stud and
nut.
(3) Screw the other 3 bolts into the remaining 3 holes, then tighten all
4 bolts securely and evenly.
Stud x1
Throttle wire (engine side)
Connector case
Close in this direction
Grip
Engine
Fig. 2
Publicité
