▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage of cordless power tools and batteries
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
8
Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1
The reciprocating saw is not in working order
Trouble or fault
Power tool does not start.
The saw blade cannot be
removed from the chuck.
8.2
The reciprocating saw is in working order
Trouble or fault
The power tool does not de-
velop full power.
The saw blade cannot be
removed from the chuck.
9
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
*2208240*
6.
Possible cause
The battery is not correctly insert-
ed.
The battery is empty.
The transport lock is engaged.
The locking sleeve is not turned as
far as it will go.
Possible cause
The control switch is not fully
pressed
Battery is discharged
The locking sleeve is not turned as
far as it will go.
2208240
Action to be taken
▶ Push the battery in until it
engages with a click.
▶ Charge the battery.
▶ Disengage the transport lock.
▶ Turn the locking sleeve as far as
it will go and remove the saw
blade.
Action to be taken
▶ Press the control switch fully.
▶ Change the battery and charge
the empty battery.
▶ Turn the locking sleeve as far as
it will go and remove the saw
blade.
English
9