Publicité
2. Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on
the nozzle extension.
3. Select desired spray tip:
•
For gentle rinse, select white 40° spray tip.
•
To scour surface, select yellow 15° or red 0°
spray tip.
•
To apply chemical, select black spray tip.
Low Pressure
High Pressure
40° White
15° Yellow
Usage Tips
•
Pull back on collar, insert new spray tip and
release collar. Tug on spray tip to make sure it is
securely in place.
•
For most effective cleaning, keep spray tip from
8 to 24 inches away from cleaning surface. If you
get spray tip too close, you may damage cleaning
surface.
•
DO NOT get closer than 6 inches when cleaning
tires.
How to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern. Always start the turbo nozzle at
a distance, gradually getting closer to the surface until
you get the cleaning force you want.
CAUTION
The turbo nozzle produces an extremely high
pressure spray which is capable of removing paint
and cutting holes through surfaces if held too close.
• Always make sure the surface you will clean will not be
damaged by the high pressure spray by testing in a
hidden area.
1. Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on
the nozzle extension.
Black
Use to apply
chemical
0° Red
2. Pull back on collar, insert turbo nozzle and release
collar. Tug on turbo nozzle to make sure it is
securely in place.
3. For most effective cleaning, keep turbo nozzle from
8 to 24 inches away from cleaning surface. If you
get turbo nozzle too close, you may damage
cleaning surface.
NOTE: Detergent cannot be applied with the turbo
nozzle.
Cleaning and Applying Chemical
IMPORTANT: Use chemicals designed specifically
for pressure washers. Household detergents could
damage the pump.
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
1. Review spray tip use.
2. Prepare detergent solution as required by
manufacturer.
3. Place filter end of detergent siphoning tube into
detergent container.
Keep the chemical injection tube from coming in
contact with the hot muffler.
• When inserting the filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently
contacting the hot muffler.
4. Make sure black spray tip is installed.
NOTE: Detergent cannot be applied with the high
pressure spray tips (White, Yellow, or Red).
5. Make sure garden hose is connected to water
inlet. Check that high pressure hose is connected
to spray gun and pump and start engine.
6. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward,
using long, even, overlapping strokes.
7. Allow detergent to soak in between 3–5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow
detergent to dry on (prevents streaking).
IMPORTANT: You must flush the chemical injection
system after each use by placing the filter into a
bucket of clean water, then run the pressure washer in
low pressure for 1-2 minutes.
11
CAUTION
CAUTION
Publicité
