Télécharger Imprimer la page

Defiant IS12a16008WD-WH Guide D'utilisation Et D'entretien page 7

Éclairage de sécurité à détecteur de mouvement

Publicité

Les langues disponibles

Les langues disponibles

Operation
1
Adjusting the lamp heads
WARNING:
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
2
Setting the sensor for testing
NOTE: When the "Test / Timer" control is set to the "Test"
night. The light will stay on for 3~5 seconds after all motion
is stopped.
Turn the "TIMER MINUTES" control to the "Test"
position.
Turn the "SENSITIVITY" control to the position
you want.
3
Adjusting the motion sensor
detection zone
Perform a "walk test": walk in an arc across
the front of the motion sensor (C).
Watch the light. The light will come on and the
detected.
Stop, wait for the light to turn off, and then
begin walking again.
Continue this process until the detection zone
has been established.
C
7
Please contact 1-866-308-3976 for further assistance.
NOTE: The motion sensor will need to completely warm
up (15 seconds) before beginning the setup process.
If needed, gently grasp the motion sensor (C)
and move it from side to side or up and down
to adjust the detection zone.
To ensure the motion sensor work properly,
please keep the marking "THIS SIDE UP" on
the motion sensor up.
HOMEDEPOT.CA

Publicité

loading

Produits Connexes pour Defiant IS12a16008WD-WH

Ce manuel est également adapté pour:

Is12a16008wd-bk1001 857 5541001 857 551