Defiant IS12a16008WD-WH Guide D'utilisation Et D'entretien page 5

Installation
1
Determining the mounting
location
NOTE:
mounted higher than recommended, aiming the sensor
down will reduce the coverage area.
□
Determine the mounting location – wall or eave
mount.
□
Position the lamp heads (A) in the general
direction of the desired light coverage.
2
Installing the mounting bracket
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
NOTE: Four mounting bracket screws of various sizes are
included. The installation will only require two. Discard the
unused mounting bracket screws after installation.
□
□
Install the mounting bracket (FF) with the
stamped word "FRONT" facing away from
the junction box. Use the mounting bracket
box. If necessary, use the screws that were
□
Firmly pull on the mounting bracket (FF) to
verify it is securely mounted to the junction
box.
FF
BB or CC
5
Wall Mount
3
Making the electrical
connections
□
Connect the white wire of the xture to the white
wire from the junction box with wire nut(DD).
□
Connect the black wire of the xture to the black
wire from the junction box with wire nut(DD).
DD
Please contact 1-866-308-3976 for further assistance.
A
Eave Mount
HOMEDEPOT.CA