Publicité
3. Push towards the rear of the oven and lift to remove to
remove the top glass cover from the oven. (Fig. 2)
Fig. 2
4. Slide the range oven into the cabinet opening. Verify that
the oven is level from side to side and front to rear. (Fig. 3)
Fig. 3
5. Fix the range oven in the cabinet opening on both left and
right using four screws (Recommend #8-15 x 3/4" wood
type, not provided) on both left and right (2 screws each
side). (Fig. 4)
Fig. 4
Gas Connection
WARNING
Gas supply pipe must be installed with clearance from
sharp objects contacting or cutting gas lines.
Connect a propane supply line with a 3/8" Flare Female
connection to the cooktop. (Fig. 5) Tighten the gas line joint
to the cooktop using 2 wrenches.
IMPORTANT: Leave adequate space around the gas supply
pipe in case of bend or damage during installation. Make sure
the gas supply pipe cannot contact any moving parts after
installed. Be sure all openings in the cabinets around the gas
line are sealed at time of installation.
Fig. 5
Pressure Check
1. Turn LP gas off to the appliance.
2. Remove the Screw with the sealing gasket from the
pressure test port on the range. (Fig. 6)
Fig. 6
3. Using the rubber tube from the pressure check measuring
device, slide the rubber tube down over the gas pressure
test port. The rubber tube should seal around the pressure
test port on the range.
4. Turn on the LP gas to the appliance.
5. The pressure gauge tester should measure between 10"
WC to 13.8" WC. (Fig. 7)
Fig. 7
6. Turn off the LP gas to the appliance.
7. Remove the rubber tube of the pressure check measuring
device.
8. Replace the screw with the gasket from step 2. Before
replacing the screw, inspect the rubber gasket seal for any
signs of damage. Replace seal if damaged.
9. Tighten the screw to 1.3 Nm to 1.7 Nm.
NOTE: Ensure the product is gas leak checked after the
pressure check test is completed by also testing the pressure
check port screw. If any leaks are detected around the
pressure check port screw and gasket, a new one can be
purchased. Call Furrion support for a replacement.
- 8 -
CCD-0005503 Rev: 01-17-23
Publicité
