Publicité
ASSEMBLY
GENERAL ASSEMBLY
STEP 1: Connect the front stabilizer (2) to the
main frame (1) using two sets of flat washers
(35), spring washers D8 (36), nuts M8 (37) and
bolt M8*45 (34). Then connect the rear stabilizer
(3) to the main frame (1) using two sets of flat
washers (35), spring washers D8 (36), nuts M8
(37) and bolt M8*45 (34).
STEP 2: The pedals (23L & 24R) are marked with
"L" and "R" - Left and Right. Connect them to their
corresponding crank arms. The right crank arm
is on the right side of the bike. Note that the right
pedal must be screwed clockwise and the left pedal
counterclockwise.
NOTE: It is a good idea to grease the threads before
attaching them to the crank, this will ensure that
they can be removed in the future. Tighten both
pedals as firmly as possible. For best performance,
keep the pedals tightened.
39
BESP-22
EN
Publicité
