electrical information
EN
5.5
control module operation
WARNING
!
•
Risk of Explosion! DO NOT reset the module more than once within a fi ve-minute time period. Gas may
accumulate in fi rebox. Call a qualifi ed service technician.
1. The control module has an ON/OFF/
REMOTE selector switch that must be set
(see Figure 9).
OFF Position: Appliance will ignore all
power inputs and will not respond to
any commands from a wall switch or
transmitter. The unit should be in the OFF
position during installation, service, fuel
conversion, and if the control goes into
LOCK-OUT mode as a result of an error
code.
ON Position: Appliance will ignite and
run continuously. This mode of operation
is primarily used for initial installation.
REMOTE Position: Appliance will initiate
commands from an optional wall switch
and/or the wireless transmitter.
2. If you intend to use both an optional wired
wall switch and the transmitter to operate
your fi replace, the wall switch will override
any commands given by the transmitter.
3. Module Reset: This module may lock-
out under certain conditions. When this
occurs, the appliance will not ignite or
respond to commands. The module will
go into lock-out mode by emitting three audible beeps, then continuously displaying a RED/GREEN error
code at its status indicator LED.
•
Turn the gas manual shut-off valve clockwise to the "OFF" position. (Shut-off valve is located on the fl ex
connector).
•
Set the module selector switch to the OFF position.
•
Wait fi ve (5) minutes to allow possible accumulated gas to clear.
•
Turn the manual shut-off valve counterclockwise to the "ON" position
•
Set the module selector switch to ON or REMOTE position.
•
Start the appliance.
4. Setting the Child Lock: Slide the battery cover down from the back of the transmitter. Slide the child lock
switch to enable or disable the child lock feature.
note:
No functions will be usable until child lock feature is disabled.
20
W415-2978 / 02.16.21
FLAME HI/LO
STATUS
Figure 9
MODULE
SELECTOR
SWITCH
NG/LP
LEARN
GAS-TYPE