Publicité
5. Repeat the above steps to save more stations.
Notes:
•
If you assign a new station to a used number (a number that
has already been assigned a station), the new station will
overwrite the old one.
•
You will lose all your preset stations if there is a power failure
or you unplug your device.
4.4.5.
TUNE IN TO A PRESET STATION
To select and tune in to any of the preset stations, use either of
the methods below when the radio is on.
•
Press the Time/Station setting button (
the preset stations (P01 to P10). Each time you press this
button, your device tunes in to the next preset station.
•
Press the Time/Station setting button (
the Hour setting/Tuning down button (
Tuning up button (
Tip: After you select a preset station, your device will briefly
display the station name (e.g. P02) and then display the station's
frequency.
4.5.
USE THE ALARMS
Your device has 2 alarms. You can use both alarms in the same
way.
4.5.1.
SET OR CHANGE AN ALARM
To set or change alarm 1, follow the steps below:
1. When your device is in time display mode, press and hold
the Alarm 1/Volume down button (
your device into alarm time setting mode. Either of the alarm
1 indicators (
2. When the digits are blinking, press the Hour setting/Tuning
down button (
press and hold this button to quickly change the value.
3. Repeat Step 2 above but press the Minute setting/Tuning up
button (
) to set the minutes.
4. Press the Alarm 1/Volume down button (
to save the alarm time and return to time display mode. Either
of the alarm 1 indicators (
5. If needed, change the alarm mode. See the section below
for more details.
Notes:
) to select a preset station.
and
) and all the digits start blinking.
) repeatedly to set the hours. Tip: You can
and
11
) to cycle through
) and then press
) or Minute setting/
) for 2 seconds to put
) or wait 5 seconds
) becomes steadily on.
EN
Publicité
