Charger Protection
No.
Charger Protection
1
Over Voltage Protection
2
Under Voltage Protection
3
Overload Protection
Over Temperature
4
Protection
5
Ground Protection
6
Leakage Protection
13
Causes/Actions
Input is greater than 120%,
the relay is turned off
Input is less than 80%, the
relay is turned off
Output current is greater
than 110%, the relay is
turned off. The power needs
to be disconnected then
restored.
When the temperature on the
main board reaches 185°F,
the power will be reduced to
50%. Once it reaches 194°F
the power will turn off
completely
The ground wire is not
detected, or the ground wire
has become disconnected
during the charge cycle. The
relay is now disconnected
CCID –
(Charge Circuit
Interrupting
Device). A safety
device that will disable utility
power to the charger in the
event that a loss of isolation
is detected.
The relay is now
disconnected
WALL MOUNT BRACKETS
The Charging Station and gun can be mounted to a wall using the supplied mounting brackets:
1)
Wall socket
2)
Charging Station Plug
3)
Charging Station
4)
Charging Station Wall Mounting Bracket
5)
Gun Holder Mounting Bracket
6)
Charging Station Gun
WARNING:
The Charging Station must be installed in a well-ventilated dry space away from any
flammable substances, gas, or oil lines.
Always coil up the gun cable after use to prevent damage occurring to the cable or the
gun.
14