Pattfield Ergo Tools PE-HWA 630 Traduction De La Notice Originale page 140

Masquer les pouces Voir aussi pour PE-HWA 630:

4. Technical data

Mains voltage/frequency .............................................. 230 V~, 50 Hz

Power consumption: ................................................................. 630 W

Pumping rate max. .................................................................3300 l/h

Delivery head max. .....................................................................36 m

Delivery pressure max. ......................................... 0.36 MPa (3.6 bar)

Suction height max. ......................................................................8 m

Pressure connection: .........................................................................

...................................................approx. 33.3 mm (R1 female thread)

Suction connection: ............................................................................

....................................................approx. 42 mm (R11/4 male thread)

Water temperature max. ............................................................. 35°C

Protection type: ........................................................................... IPX4

5. Before starting the equipment

Before you connect the equipment to the mains supply make sure

that the data on the rating plate are identical to the mains data.

As a basic principle, we recommend the use of a preliminary ﬁ lter

and a suction set with suction hose, intake cage and non-return val-

ve, in order to prevent long priming periods and unnecessary dama-

ge to the pump as a result of stones and solid foreign bodies.

5.1 Connecting the intake line

•

Fasten the suction hose (at least approx. 19 mm (¾") plastic hose

with spiral reinforcement) to the suction connection (1) approx. 42

mm (R11/4 male thread) of the equipment either directly or via a

threaded nipple.

•

The suction hose used should be equipped with an intake valve.

If the intake valve cannot be used, a non-return valve should be

installed in the intake line.

Anl_PE-HWA_630_SPK7.indb 140

- 140 -

28.01.2022 11:05:05