Publicité
HANGING THE HEATER IN THE BRACKET
1.
Lift the heater into the mounting bracket and align the lower bracket holes with the threaded
holes.
2.
Thread a large knob-screw through the hole on each side of the bracket.
3.
Aim the heater horizontally or tilted by aligning the upper
bracket holes with the top threaded holes on the heater and secure with the small knob-screws
and tighten all. See Figure 5.
Remove screws from the
panel to access power
block, see Figure 7.
CONNECTING THE POWER:
1.
With the power off at the breaker, remove all screws from the bottom lid for access to the
electrical section of the heater.
2.
Attach flexible cable through a knock-out in the side of the heater following NEC and local
codes, See Figure 6 and SPECIFICATIONS for recommended wiring and circuit breakers.
NOTE: For certain applications, conduit may be required (See Figure 6). Check local electrical
codes. If you run the wiring in conduit and wish to be able to turn the heater be sure to
purchase enough flexible conduit to allow the heater to be turned.
Use top slots/hole in bracket
and small knob-screws if heater
is to be tilted down.
Adjust louvers up or down to
control air flow.
Figure 5
Page 6
Publicité
