Télécharger Imprimer la page

Dura Heat EWH5100 Instructions D'installation Et Manuel D'utilisation page 3

Publicité

Page 3
GENERAL SAFETY INFORMATION:
WARNING-Read and understand installation and operation instructions and observe all safety instructions
For supply connections, use only copper wire, see SPECIFICATIONS
1.
2.
Heater air flow must be directed parallel to, or away from adjacent wall.
3.
Observe wall, floor, and ceiling clearance requirements, see Figure.1.
4.
All wiring must conform to national and local electrical codes in the United States and the heater must be
grounded as a precaution against possible electrical shock. Heater circuits must be protected with
proper fuses or circuit breakers.
5.
The mounting structure and the anchoring hardware must be capable of reliably supporting the weight of
the heater and, if used, the mounting bracket.
6.
All electrical power must be disconnected, and the main service box must be locked before inspection,
cleaning or servicing the heater. This is a precaution to prevent serious shock.
7.
This heater is not suitable for use in hazardous locations as defined by the National Fire Protection
Association (NFPA) in the United States. This heater has hot and arcing (sparking) parts inside. Do not use in
8.
This heater is not suitable for use in corrosive atmosphere such as marine, greenhouses or chemical storage
areas where gasoline, paint, or flammable liquids are used or stored.
9.
Do not install closer than 8 inches to a vertical surface. Do not install less than 6 feet from the floor.
10.
Extreme caution is necessary when any heater is used by or near children or invalids and whenever the
heater is left operating and unattended.
11.
Use this heater only as described in this manual. Any other use not recommended by the manufacturer may
cause fire, electric shock, or injury to persons.
WARNING: SHOCK HAZARD
Use your heater only in dry environments. This heater is not intended for use in a bathroom, laundry area, or similar locations, or
near sinks,washing machines, swimming pools or other sources of water. Never locate heater where it may fall into a bathtub or
other water container. Do not use heater outdoors. Do not use in damp environments such as flooded basements.
WARNING: HOT SURFACES
Do not touch body of heater when in use. This heater is hot when in use,to avoid burns, do not let bare skin touch hot surfaces.
If provided, use handles when moving this heater.
WARNING: FIRE HAZARD
Heater has hot and arcing or sparking parts inside. Do not use near combustible materials or flammable gases or sources of heat.
DO NOT USE in areas where gasoline, paint or flammable materials are used or stored. Keep combustible materials such as
furniture, pillows, bedding,papers, clothes and curtains at least 3 feet (0.9 m) from the front of the heater and keep them away
from the sides and rear. Keep rear grille away from walls or drapes so as to not block air intake. To prevent a possible fire, do not
block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. Do not
insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock, fire, or damage
the heater
WARNING: ELECTRICAL SHOCK HAZARD
Do not use with damaged wiring. Use with
adequate electrical system that is up to
code.
Do not operate any heater with a damaged cord or plug or after heater malfunctions, has been dropped or damaged in any
manner. Do not operate heater with a broken heating element or ceramic cone or any visual imperfections.
SAVE THESE INSTRUCTIONS
WARNING
Improper installation or failure to follow the
-
procedures outlined in this instruction manual can result in serious
READ & SAVE THESE INSTRUCTIONS
PET OWNERS NOTE:The health of birds and some small pets are extremely
sensitive to the fumes given off during the initial use of many appliances.
Although these fumes are not harmful to humans, it is recommended that
this heater not be used around birds and small pets during its initial use
until the manufacturing corrosion coatings burn off.
electrical shock.

Publicité

loading