Publicité
Page 5
INSTALLING THE HEATER:
LOCATING THE HEATER:
Install the heater out of traffic areas, maintaining the clearances stated in Figure 1 above. The air
flow from the heater must not be restricted or obstructed by any items in the room. When more than
one heater is used in an area, the heaters should be arranged so that the air discharge of each heater
supports the air flow of the others to provide best circulation of warm air, as
indicated below in Figure 3.
MOUNTING BRACKET INSTALLATION
Refer to Figure 4a and 4b.
1.
Locate a ceiling joist or other firm structural element or support to mount the heater and point
at desired direction of air flow.
2.
Drill a ¼" pilot hole in the ceiling joist for the screw(s).
3.
Place the screw(s) and washers as shown in the Figures 4a or 4b.
Figure 4a: For Single-Screw Mounting (center bracket hole only).
(If you want to swivel the heater, a longer Lag bolt may be required to properly secure the
heater, not included.
Figure 4b: For Double-Screw Mounting (both off-center holes are used).
4.
Tighten the screws to secure the heater.
Publicité
