BST LAB10-R Manuel D'utilisation page 6

LAB10-R
FADER CONTROL SECTION
42. CHANNEL FADER
The fader controls the channel's level from off to unity gain at the "U" marking, on up to 10dB of the additional gain.
43. STEREO FADER
Adjusts the signal level sent to the STEREO channels.
44. MP3 FADER
The fader controls the MP3 player volume.
45. MAIN OUTPUT (L/R) FADER
These are the master faders that control the levels at the MAIN OUTS from off to unity gain at the "U" marking, on up to 10dB of the additional gain.
46. GROUP 1 AND GROUP2 FADER
This fader controls the level of the group (G1 & G2).
47. FX RTN FADER
This fader let you adjust how much of the internal effects from processor to the main mix. The fader also allow you to adjust the level of signals coming
into the FX Return inputs from external processors, being added to the main mix.
FEATURESON BACK PANEL
48. POWER SWITCH
Press this switch to turn on the mixer. The front panel power LED will come on.
49. POWER CONNECTION
This jack accepts the supplied IEC AC power cord. Before you plug the AC power cord into the powered mixer, make sure that the voltage of your unit
is the same voltage as your local AC mains supply. Use only the power cord supplied.
© Copyright LOTRONIC 2016
LOTRONIC SA
Avenue Zénobe Gramme 9
1480 SAINTES
Belgium
BSTDJ.COM
Page 6