SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
G3623DA: Cordless Disc Grinder
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
Always operate the power tool with two hands
Not for cut-off operations
When using a cutting-off wheel, be sure to
attach the type A wheel guard.
when using a type B wheel guard for cutting-off
operations with bonded cut-off wheels, there is
an increased risk of exposure to emitted sparks
and particles, as well as exposure to wheel
fragments in the event of a wheel burst.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment and
its implementation in accordance with national law,
electric tools that have reached the end of their life
must be collected separately and returned to an
environmentally compatible recycling facility.
V
Rated voltage
n
Rated no-load speed
0
min
Revolution or reciprocations per minute
-1
Switching ON
Switching OFF
Lock
Switching locks to the "ON" position
Disconnect the battery
Warning
Remaining battery indicator switch
Battery
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50% – 75%.
Lights ;
The battery remaining power is 25% – 50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 312.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Removal of casting fi n and fi nishing of various types of
steel, bronze and aluminum materials and castings.
○ Grinding of welded sections or sections cut by means of
a cutting torch.
○ Grinding of synthetic resins, slate, brick, marble, etc.
SPECIFICATIONS
1. Power tool
Voltage
Rated no-load speed
Outer dia.
Wheel
Hole dia.
Thickness
Peripheral speed
Battery available for this tool*
Weight**
*
Existing
batteries
series, etc.) and AC/DC adapter (ET36A) cannot be
used with this tool.
** Weight: According to EPTA-Procedure 01/2014
Depending on attached battery. The heaviest weight is
measured with BSL36B18X.
Also, the weight includes the wheel guard, side handle,
wheel washer, and wheel nut.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
Electronic control
● Soft start
Reduces recoil against the operator by managing the
number of rotations during startup.
● Braking Function
Brake is activated when the switch is turned off, stopping
the motor's rotation.
13
English
Model
G3623DA
36 V
5300 min
-1
Auto mode: 3200 min
230 mm
22.23 mm
6 mm
80 m/s
BSL36B18X
5.1 kg
(BSL3660/3620/3626,
-1
BSL18xx