Use The Air Purifier; Understand The Air Quality Light; Understand The Healthy Air Protect Alert; Switch On - Philips AC4012 Mode D'emploi

4 Use the air
purifier
Understand the air
quality light
Color of the air
quality light ring
Blue
Purple
Red
The air quality light automatically goes
on when the purifier is switched on.
Note
• The built-in air quality sensor measures
the air quality and automatically selects
the appropriate color of the air quality
light. When the air is clean, the color
of the air quality light is in blue. When
the air quality deteriorates, the color of
the air quality light changes to purple
or red.
Understand the healthy
air protect alert
The filter replacement light (
indicates the filters have to be replaced
(fig h).
Healthy air protect alert Follow this
Filter replacement light
is on continuously.
This lasts approximately
for 2 weeks. On the last
day of 2 weeks, the
purifier beeps every 30
minutes to inform you
that the filters need to
be replaced.
EN
6
Air quality level
Good
Fair
Bad
)
Replace the
NanoProtect
Activated
Carbon filter
and the
NanoProtect
filter.

Switch on

1
Put the plug of the air purifier into
the power outlet.
» All lights go on twice and you
hear a beep. Then, the lights go
out again.
2
Press the button to switch on the
purifier (fig i).
» The air quality light shows the
current air quality.
» The fan speed
(fig j).
3
Press the button to switch off the
purifier.
Set the sensitivity of the
air quality sensor
People with certain health problems
(for example: allergies or asthma) have
a greater need for healthy air. For this
reason, the purifier allows you to adjust
the sensitivity of the air quality sensor. If
you set it to higher sensitivity level, the
purifier starts cleaning the air at lower
pollution level.
There are 3 sensitivity levels:
•
Extra sensitive (default setting)
•
Sensitive
•
Standard
You can adjust the sensitivity of the air
quality sensor in the following way.
Note
• When it is set to a higher sensitivity,
the purifier starts cleaning the air at
lower pollution levels to make the air
even cleaner. Plug the purifier before
adjusting the sensitivity of the air
quality sensor.
light goes on