Télécharger Imprimer la page

Hoover HFLF3518EW Mode D'emploi page 10

Masquer les pouces Voir aussi pour HFLF3518EW:

Publicité

Wi-Fi Use
To activate the Wi-Fi, long press the Wi-Fi key for 2 seconds, the Wi-Fi icon will turn on and an acoustic
signal is made.
If the Wi-Fi has not been configured yet, when the refrigerator turns on, it will automatically enter the
configuration mode and keep this status for 30 minutes. To use the configuration mode:
Press the Wi-Fi key for 2s, the refrigerator enters the Wi-Fi configuration mode and an
acoustic signal is made. The Wi-Fi icon starts blinking.
Follow in app instructions to configure the Wi-Fi (see above).
Once the Wi-Fi is configured and the connection established, the Wi-Fi icon is on and fixed.
After 30 minutes without performing any operation, the Wi-Fi will automatically exit the
configuration mode.
If the Wi-Fi has already been configured, it will automatically reconnect according to the
configuration information.
To reset the Wi-Fi, long press the Wi-Fi – Set key for 2s, the Wi-Fi is reset and an acoustic signal is
made. After this, the Wi-Fi will automatically enter the configuration state (Wi-Fi icon will start blinking
again).
To turn off the Wi-Fi, press the Wi-Fi key.
Radio-module - Technical data
Frequency rate (OFR)
Channel frequencies
Maximum power(EIRP)
Radio equipment type is in compliance with Directive 2014/53/EU.
2400 MHz-2843.5 MHz
2412...2472 MHz(step size 5 MHz)
100 mW
EN 8

Publicité

loading