Publicité
Adding a Repeater to the Panel
NOTE: If adding a repeater to the LightSYS Plus, the LightSYS Plus control panel must
include a wireless Video Module.
1. From the panel's Installer Menu,
Agility/WiComm: go to Programming > Radio Devices > Allocation > RF / Code
LightSYS Plus/LightSYS Air: go to Install > WL Device > Allocation > By RF/Code
2. Click <OK>.
3. If by RF: Apply a long press to the repeater's front tamper switch for 5 sec. (the back
tamper is already closed); the blue repeater LED flashes to confirm the action.
4. If by Code: Enter the serial number of the repeater.
5. Repeat step 3 to learn additional repeaters.
Adding a Device to the Repeater
1. Select a device (such as, zone, siren, keypad or I/O expander) to assign the repeater
to.
Note: Keyfobs are automatically added to a repeater and there is consequently no
need to manually add a keyfob to a repeater.
2. For example, to add a detector to a repeater:
From the panel's Installer Menu, go to Programming > Radio Devices > Modification
> Zones > Parameter / Select Zone > Advanced Controls > 8) Change Assign
3. Select Via Repeater.
4. Click <OK>.
5. Repeat steps 1 to 4 to learn additional detectors for a maximum of 32 detectors per
repeater.
NOTE: When exiting Installer Mode, the panel sends the updated list to the repeater.
7
Publicité
