Publicité
3. LED Indication
GREEN
Flashes: Normal operation mode
RED
ON: Battery charging
OFF: Discharging state or Charging problem (a trouble condition will
also exist in the panel and the the Orange LED will flash) or battery
status LED is disabled
BLUE
Flashes (1 sec.): Add / remove device from receiver.
Repeater transmitting
Flashes rapidly: Repeater upgrade
ORANGE
Flashes: Trouble
4. Installation
The repeater should be mounted at a location that provides good reception range with
the panel. Mount the repeater between the devices and the control panel at a minimum
height of 1.5 m from the ground or 50 cm below a ceiling.
NOTE: Do not mount the repeater near large metal objects or close to radiating
electronic devices such as computers and monitors, which may reduce the sensitivity.
Installing the Repeater
1. Open the cover by twisting a screwdriver in the slot on the bottom of the case (see
Figure 1).
2. Punch out holes for the mounting screws and for the entry of the power wires and
then mount the repeater on the wall (see Figure 2).
3. Remove the battery divider and then connect a power source of 10 to 16 volts AC or
DC to the AC/DC terminals (see Figure 2).
4. Close the cover (see Figure 3).
NOTE: If you intend to add a repeater/repeaters by RF, make sure to complete the
procedure in the "Adding a Repeater to the Panel" section (below) before closing the cover.
5. Secure with cover screw (see Figure 4).
5
Publicité
