Publicité
EN
Technical data
Operating data
Operating pressure (ideal)
Operating pressure (max.)*
Operating pressure (min.)*
Water temperature (ideal)
Water temperature (max.)
Hole Size For Faucet
Certifies this faucet complies with ASME A112.18.1 / CSA B125.1 & NSF 61, NSF 372 and
AB1953. The faucet also complies with water usage requirements of the California
Energy Comission and the US Department of Energy.
INSTALLATION INSTRUCTIONS
1. Remove all contents from the package
and check for completeness.
2. Turn off water supply.
3. Cut a mounting hole 1 3/8" diameter
(35mm) in the desired position in
counter top or sink (if one isn't
available).
4. Connect the Pull Down Spray Assy
(3) to the Pull Down Hose (1) hand tight.
Ensure the Rubber Washer (2) is in place
in the Pull Down Hose (1).
5. Place the Base-O-Ring (5) over the
mounting shank.
ATTENTION: Base-O-Ring (5) should
be sitting between the countertop and
faucet base.
DO NOT use putty or other sealant at
this location.
NOTES: Solid surface installation: The
countertop mounting surface needs
to be flat and free of debris otherwise
the faucet may not sit properly. For tile
Value
45 PSI
3 bar
300 kPa
70 PSI
5 bar
500 kPa
14.5 PSI
1 bar
100 kPa
140°F
60°C
158°F
70°C
1
3/8
"
35mm
installations, avoid installing faucet near
or on top of grout lines. This may cause
a weak joint between the faucet and the
counter and could cause leaks.
6. Install the mounting hardware to
the mounting shank of the faucet (4)
underneath the mounting surface in
the following order: Plastic flange (6)
rubber washer (7) and fixing plate (8) as
illustrated.
7. Secure the faucet by tightening the
fixing nut (9) onto the mounting shank of
the faucet body (4).
8. Connect the fexible supply hoses (10)
to the water supply in the house.
9. Remove the aerator using the aerator
key (fig. 2B), turn on water, flush the
faucet for any debris (fig. 2C) and check
for leaks.
Reinstall the aerator (fig. 2D) and ensure
everything is functioning properly.
– 4 –
Publicité
