Publicité
1. With the hood lamp turned on, touch
key for more than 2 seconds.
ð The lamp changes to the other
colour shade.
2. If you continue to touch the
will change to the next colour shade
after every 2 seconds. According to the
desired colour shade, stop touching
key when the lamp is in that colour
shade. The colour shade will automat-
ically activate.
You can only change the light col-
our shade while the lamp has high
light intensity.
In the event of a power outage,
your hood will remember the colour
shade set and the lamp will work in
the colour that was last set.
Aluminium filter fill warning
The light of Speed 2 key flashes for thirty
seconds after every 100 hours of opera-
tion. Clean the aluminium filters. After
cleaning, the lamp warning of Speed 2 key
does not turn off automatically. This
product continues to show the 30-second
warning when the product switches off
after every operation. When you touch the
Speed 2 key for more than 3 seconds, alu-
minium filter fill warning is reset and the
lamp is turned off.
The warning is not cancelled if the
power is cut when the hood gives
aluminium filter fill warning. When
the power is available, it continues
to warn with the light of Speed 2
key flashing.
If you run the hood at any speed
level with the aluminium filter fill
warning, the warning will not ap-
pear for as long as the hood is run-
ning. When you turn off the hood,
the fill warning starts flashing
again for 30 seconds.
If you turn off the warning without
cleaning the aluminium filter, the
operating time of 100 hours is re-
set and it starts over. At the end of
the next 100 hours, your hood
warns again.
key, it
Carbon filter fill warning (for products with
carbon filter)
The light of Speed 2 key flashes for thirty
seconds after every 100 hours of opera-
tion. In this case, you must replace your
carbon filter. Consult an authorized service
for this. After replacement, the lamp warn-
ing of Speed 2 key does not turn off auto-
matically. This product continues to show
the 30-second warning when the product
switches off after every operation. When
you touch the Speed 2 key for more than 3
seconds, carbon filter fill warning is reset
and the lamp is turned off.
The warning is not cancelled if the
power is cut when the hood gives
carbon filter fill warning. When the
power is available, it continues to
warn with the light of Speed 2 key
flashing.
If you run your hood at any speed
level with the carbon filter fill warn-
ing, the warning will not appear for
as long as the hood is running.
When you turn off the hood, the fill
warning starts flashing again for
30 seconds.
If you turn off the warning without
replacing the carbon filter, the op-
erating time of 100 hours is reset
and it starts over. At the end of the
next 100 hours, warning is given
again.
EN / 15
EN
FR
PL
Publicité
