Filling The Spray Reservoir; Attach The Spray Device To The Strap - Dogtek NoBark Spray Guide De L'utilisateur

Filling the spray reservoir:

Step 1: Hold the spray device with the fill port facing up.
Step 2: Turn the spray can upside down and place the
nozzle in the fill port. Using firm pressure, push down on
the can and hold for 15 seconds.
Repeat the step 2 and hold for an additional 5 seconds
to fully fill, increase the downward pressure on the can to
get a better connection. Don't worry, you cannot overfill
the device.
NOTE: WHEN THE RESERVOIR IS FULL THERE WILL BE APPROXIMATELY
15 SPRAYS.
Attach the spray device to the strap: Place the device so that the fill port and spray valve are
facing up and the microphone is facing you.
01
REMOVE THE KEEPER
FROM THE STRAP.
05
PLACE THE KEEPER
BACK ON THE STRAP.
THE TAPERED EDGE OF
THE KEEPER SHOULD
FACE THE INSIDE.
02
HOLD THE STRAP IN
YOUR RIGHT HAND.
THREAD THE STRAP
FROM BACK TO FRONT
THROUGH THE EAR ON
THE RIGHT.
06
ATTACH THE QUICK-
SNAP BUCKLE TO THE
STRAP. FEED THE FREE
EDGE OF THE STRAP
INTO THE SLOT THAT
IS CLOSEST TO THE
CENTER, STARTING ON
THE INSIDE OF THE
CURVE.
03
BRING THE STRAP
AROUND THE FRONT/
FACE AND THEN
THREAD IT FRONT TO
BACK THROUGH THE
EAR ON THE LEFT.
07
NEXT, FEED THE FREE
END THROUGH THE SLOT
ON THE EDGE OF THE
BUCKLE.
6
04
MAKE SURE NOT
TO COVER THE
MICROPHONE WITH THE
STRAP.
08
PASS THE LOOSE STRAP
THROUGH THE KEEPER.