Publicité
m
CAUTION! DANGER OF POISONING
AND DAMAGE TO PROPERTY! Do not
light any fires within the product and keep it
away from sources of heat.
You should also familiarize yourself with the
local fire protection regulations (e.g. camping
site, tent pitch).
m
WARNING! DANGER OF
SUFFOCATION! If the inside of the tent is
not adequately ventilated, there is a risk of
suffocation.
If using gas or other combustion appliances
additional ventilation will be required.
Make sure that the vents on the side of the
inner tent are not covered at any time.
Do not leave children unattended in the tent.
WARNING! Do not use high voltage
appliances or hot appliances in the tent,
as this may cause fire or electric shock.
˜ Fire precautions
Camp safely. Follow these common sense
rules:
Do not place hot appliances near the walls,
roof or curtains.
Always observe the safety instructions for these
appliances.
Never allow children to play near hot
appliances.
Keep exits clear. Do not block the exit with
objects.
Make sure you know the fire precaution
arrangements on the site.
6
GB/IE/NI
˜ Tent assembly
Please ensure that the product is only
assembled by people with the appropriate
skills.
Note: The polyester material of the tent
consists of water-repellent material.
It is possible that during the first rainfall the tent
will not be completely watertight. However, the
threads of the tent will contract when exposed
to water so that after a short time the tent will
become watertight.
Do not pitch the tent on a sloping ground.
Erect the product in accordance with the
illustrations A to F.
Illustration A:
1. Remove the tent and all accessories from the
retail pack.
2. Lay the outer tent
1 ]
[
unfolded on the ground where it is to be
pitched. The opening for the poles must be on
the outside of the tent.
3. Unfold the poles and assemble the individual
parts together one at a time.
4. Carefully guide the poles
openings provided for them.
5. Fix each end loop with a peg
ground.
Illustration B:
6. Lift the tent and guide the poles
the pins provided on the ground. The frame is
now set up and under tension. Avoid over-
tensioning. If the tension is too high, the tent
may tear.
7. Attach the pole clip to the poles.
flat and completely
through the
3 ]
[
4 ]
[
in the
6 ]
[
into
3 ]
[
4 ]
[
Publicité
