Publicité
ENGLISH
4. Then screw in the previous fixing screw by aligning the hole in the screw and the hole at
the bottom of the fan.
5. Finally, tighten the other two fixing screws to secure the LED plate.
NOTE: during the installation or when the LED lamp is removed, keep the insulation pads intact.
Over-tightening the screws may damage them.
Light installation
Figure 11
Restore the cover and the light back to the LED plate and secure them with decorative clips
and bolt nuts.
Lampshade installation
Figure 12
1. Restore the cover and the lampshade back to the LED plate and secure them with
decorative clips and bolt nuts.
4. OPERATION
This fan can be operated with the remote control.
Fig. 13
1. Power indicator light
2. Speed buttons
3. Off button
4. Timer buttons
5. Light button
6. Battery compartment
-
The indicator will light up while the appliance is in operation.
-
Use the speed buttons to select the power level. 3 speeds available:
-
I
-
II
-
III
-
Press the power button to switch the appliance off.
-
Use the timer buttons to select the operation time of the appliance. Select up to 8 hours
of operation.
NOTE: once the selected time has elapsed, the fan will switch off automatically.
52
ENERGYSILENCE AERO 4265 GOLDBLACK | GOLDWHITE
Publicité
