Publicité
ENGLISH
Fig. 6 key
1. Electric wiring
2. Hanging ball slot
3. Clevis
4. Adapter
5. Canopy
6. Canopy decorative cover
7. Pin
8. Fixing screw
-
If you want the fan to hang lower, you must remove the hanging ball from the supplied 6
inch downrod for use with a longer rod (included). If you wish to use the 6-inch downrod,
follow the steps below.
-
To remove the hanging ball, loosen the suspension ball locking screw and remove the pin
and clevis. Lower the hanging ball and remove the clevis pin. Slide the hanging ball off the
downrod and slide it onto the longer rod (note that the top of the rod has a hole for the
locking screw).
-
Insert the stop pin into the top of the extended downrod and raise the hanging ball. Make
sure that the stop pin is aligned with the slots on the inside of the hanging ball, tighten the
fixing screw securely.
Tip: to prepare for passing the electrical wires through the rod, attach a small piece of electrical
tape to the ends of the electrical wires to hold them together when passing them through the
rod.
-
Loosen the main-body attachment fixing screws and nut at the top of the motor housing.
Remove the pin and rod clip (if you have not already done so). Slide the rod down through
the canopy.
-
Pass the electrical wires through the rod and pull the wires protruding from the top of the
rod end.
-
Place the main-body attachment downrod into the main body anchorage of the motor
housing and insert the pin and clip previously removed. Tighten the fixing screws and the
main-body attachment nut securely. Lower the canopy onto the motor housing
Warning
The important safety precautions and instructions stated in this manual are not meant to
cover all possible conditions and situations that may occur.
Bear in mind that common sense and caution are necessary factors in the installation and
operation of this fan.
50
ENERGYSILENCE AERO 4265 GOLDBLACK | GOLDWHITE
Publicité
