Publicité
Connectivity
The connection cables coming out from the downrod and hanging ball must be connected
according to Fig. 7.
Warning
-
Before handling the cables, make sure all the poles are disconnected from the power
supply.
-
The fan includes a remote-control unit with radio frequency, it does not have a speed
control chain. It can only be controlled through the remote control inside the box.
-
2 people are needed to carry out the cable connection step. It is suggested that 1 person
holds the assembled device while the other one connects the cables.
Canopy assembly
Figure 8
1. Lift the canopy up to the mounting bracket, aligning the loosened screws in the bracket
with the holes in the canopy.
2. Turn the canopy to lock it. Re-insert the screws and secure them all with a screwdriver.
Once you have secured the mounting bracket to the connection cover, you can hang the fan.
-
Hold the fan firmly with both hands. Slide the downrod through the opening in the mounting
bracket and allow the ball to rest on the bracket.
-
Rotate the hole in the hanging ball until it aligns with the tab on the mounting bracket.
Tip: have someone else hold the ladder securely and bring the fan closer to you once it is on
the ladder.
Installing the blades
Figure 9
Tip: blade bolt washers can be installed on each blade prior to installation.
1. Align the holes in the blades with the screw holes in the motor. Once all blades are
attached, tighten all the screws. Before securing screws permanently, repeat with the
remaining blades.
Note: tighten the blade screws a second time.
Installing the LED lamp plate
Figure 10
1. Unscrew the screws.
2. Attach the LED plate to the bottom of the fan by inserting the fixing screws into the holes.
3. Then turn it until it is firmly in place.
ENERGYSILENCE AERO 4265 GOLDBLACK | GOLDWHITE
ENGLISH
51
Publicité
