Publicité
INSTALLATION
After unpacking, check for completeness of
delivery and for shipping damage. If your
delivery is damaged or incomplete, please
contact our after-sales service.
- Assemble main body
Insert the upper stand tube (10) to the
bottom of the engine unit and tighten the
upper
anticlockwise.
Then insert the lower stand tube (11) to the
upper stand tube, and tighten the lower
stand tube (11) by turning it anticlockwise.
Finally insert the lower stand tube (11) to the
hole on the base (12), and tighten the lower
stand tube (11) by turning it clockwise.
Remember not to over-tighten it.
- Fix the rear guard (5)
Remove the blade assembly nut (2) and the
rear guard nut (4) from the engine shaft (6).
stand
tube
(10)
Page 23 of 30
by
turning
it
Publicité
