Télécharger Imprimer la page

SAS RM62S-6.5 Traduction De La Notice Originale page 80

Publicité

9.2
Lubricating plan
To ensure that moving parts can move freely, we recommend lubricating the following points at least once a year.
Use a cloth to clean all points to be lubricated before greasing or spraying. Do not use water, so as to avoid possible
corrosion.
Lubrication points:
■ Spray oil onto the bearings of the front axle on the frame.
■ Pivoting and bearing points: Lubricate all movable pivoting and bearing points.
9.3
Cleaning the air filter (15)
The air filter must be cleaned according to the maintenance schedule. To remove the air filter proceed as follows:
IMPORTANT!
Risk of property damage!
Engine components can be damaged due to dirt ingress when cleaning the air filter!
■ Make sure that the area surrounding the air filter is clean and that no dirt gets into the intake
port of the engine when the air filter is pulled off.
1. Switch off the engine and remove the ignition key.
2. Wait until the engine has cooled down.
3. Unscrew the mounting screw (15/1).
4. Pull the air filter cover (15/2) upwards off the guide.
5. Pull the air filter (15/3) off the guide.
6. Clean the air filter or renew it if necessary.
7. Reinstall the air filter in reverse order and tighten the mounting screw (15/1) again.
9.4
Checking the spark plug (16, 17)
The spark plug must be checked according to the maintenance schedule and exchanged if necessary.
Spare spark plug:
Please note that the spare spark plug used by the equipment manufacturer may differ from the engine manufacturer's
specifications due to specific applications.
NOTE
For more detailed information, please refer to the separate operating instructions
for the engine.
NOTE
All work on the spark plug is only allowed to be carried out when the engine
is stopped and has cooled down fully.
NOTE
Always replace the old spark plug with a new spark plug with the same characteristics.
1 Remove the spark plug connector (16/1) from the spark plug (16/2) (16/a).
2. Unscrew the spark plug with the supplied spanner (17/1) (17/a).
3. Check the electrode gap (A) and reset it if necessary (17).
EN
32

Publicité

loading

Produits Connexes pour SAS RM62S-6.5