Publicité
6.5.1
Checking the brake contact switch (03, 04)
The brake contact switch ensures that the engine cannot be started if the brake is not applied.
Precondition: The engine is off.
1. Sit on the operator's seat.
2. Release the parking brake by applying the brake/clutch pedal (03/F).
3. Release the brake/clutch pedal or the brake pedal again.
4. Attempt to start the engine, i.e. ignition key in position II (04).
NOTE
The engine is not allowed to start!
6.5.2
Checking the mower mechanism contact switch
The mower mechanism contact switch ensures that the engine cannot be started if the mower mechanism is activated.
Precondition: The engine is off.
1. Sit on the operator's seat.
2. Apply the brake/clutch pedal or the brake pedal (see chapter 5.3 "Brake/clutch pedal (05) ", page 19).
3. Engage the mower mechanism (see chapter 5.5 "Operating the mower mechanism (07,08)", page 20).
4. Attempt to start the engine, i.e. ignition key in position II (04).
NOTE
The engine is not allowed to start!
6.5.3
Checking the seat contact switch (14)
The seat contact switch (14/1) ensures that the engine cuts off when nobody is on the operator's seat when the mower
mechanism is switched on or when the parking brake is not locked.
1. Sit on the operator's seat.
2. Apply the brake/clutch pedal or the brake pedal (see chapter 5.3 "Brake/clutch pedal (05) ", page 19).
3. Start the engine and let it run at maximum rpm (see chapter 7.4 "Starting and shutting off the engine", page 19).
4. Engage the mower mechanism (see chapter 5.5 "Operating the mower mechanism (07, 08)", page 20).
5. Take your weight off the seat by standing up (do not get off!).
NOTE
The engine must switch itself off!
6.5.4
Visual inspection of the mower mechanism and belt covers
Check that the mower mechanism and belt covers are undamaged and thus prevent access to the mower mechanism
and the drive belts. If damaged, contact a customer service workshop.
EN
23
Publicité
