Installing Nylon Line Cutting Head; U-Handle Version - Shindaiwa T226S Manuel D'utilisation

Installing nylon line cutting head

U-handle version

U-handle assembly
Before you start
Fix output shaft securely using locking tool in order to
prevent it form rotating when nylon cutting head is
mounted.
1. Insert locking tool into a hole located on the right side of an-
gle transmission while forcing retainer spring to the left side.
2. Insert locking tool further into blade retainer fixing slot (A) to
fix output shaft.
3. Thread nylon line cutting head (B) onto shaft (anticlockwise)
until it is tight.
4. Remove locking tool (C).
1. Loosen handle bar support bolts (A).
2. Locate handle bar in a comfortable operating position and
tighten 4 bolts (M5×25).
Install the handle so that it does not hide any of the
safety decals.
3. To eliminate loosening of throttle wire (B) fix it to shaft tube
(2 places) (C) and to right hand U-handle (1 place) with wire
fixing clips (D).
After assembly, adjust the play of wire end (E) on carburet-
tor (F) side to 1 mm - 2 mm.
G: Nuts
11
CAUTION
CAUTION
CAUTION