Publicité
CONNECTING THE APPLIANCE
1. Make sure that the voltage in your home corresponds with the voltage of the appliance.
2. Make sure that the electrical system in your home is supplied with a 16 Amp fuse.
Note:
If you replace the supplied mains cable, make sure that the new mains cable has a minimum core
cross section of 2.5 mm2 and a length of 1.5 m. If you use a mains cable that is too short, you cannot
connect the appliance and position it in the kitchen furniture before connecting the appliance to the
mains socket.
3. Use the supplied mains cable to connect the appliance to the mains socket.
After connecting, the clock shows '00:00' and you will hear a sound signal.
5
Operation
PREPARING FOR OPERATION
1. Clean the appliance and the accessories. Use warm water and a mild cleaning agent.
2. Rinse the appliance and the accessories thoroughly with water.
3. Dry the appliance and the accessories.
4. Use the oven function for 60 minutes with a temperature of 250°C to remove any production residues, such as oil
and to prevent bad smells. Refer to section
Warning:
Make sure that the room is properly ventilated.
5. Let the appliance cool down.
6. Clean the appliance again. Use warm water and a mild cleaning agent.
7. Rinse the appliance thoroughly with water.
8. Dry the appliance.
9. Install the guide racks. Refer to sections
INSTALLING THE HOOKS FOR THE GUIDE RACKS
1. Identify the hooks for the rear (A) and the front (B).
2. Install the hook (C) in the top opening (D).
3. Install the hook in the bottom opening (E).
4. Push the hook down.
5. Repeat the procedure for the other hooks.
INSTALLING THE GUIDE RACKS
Note:
The procedure shows the installation for the guide rack of the right side of the appliance. The procedure
for the left side is the same, however the hooks are mirrored.
1. Identify the guide racks for the left side (A) and the right side (B).
2. Carefully push the guide rack (C) in the hook (D).
3. Push the rack to the rear of the appliance.
4. Push the rack down.
5. Install the clamping bushes (E).
Using the oven function
Installing the hooks for the guide racks
.
Installing the guide racks
and
.
(Figure 5)
(Figure 6)
(Figure 7)
English
•
37
Publicité
