Publicité
DOOR REVERSAL
1. Unplug the appliance before reversing the door opening direction.
2. Remove food from the appliance.
3. Remove caps on the front of the refrigerator body (Fig. 1, Fig 2).
4. Remove the two screws, which attach the upper hinge to the ap-
pliance door (Fig. 3). Take special care and hold the appliance door
vertically.
5. Holding the door, swing the upper door hinge away from the door
using the other hand (Fig. 4).
Be especially careful during this step, as the hinge may close and cause
injury.
6. Remove the two screws, which attach the lower hinge to the appli-
ance door (Fig. 5). Take special care and hold the appliance door
with the other hand.
7. Holding the door, swing the lower door hinge away from the door
using the other hand, then detach the door from the appliance body
(Fig. 6).
8. Remove the two screws , which attach the upper hinge to the body
and the two screws holding the lower hinge to the appliance body
(Fig. 7).
9. Screw the upper and lower hinge on the opposite side of the ap-
pliance body using suitable screws (Fig. 8). Upper hinge should be
mounted on the other side of the appliance as the lower hinge. The
lower hinge should be mounted on the other side of the appliance
as the upper hinge.
10. With the hinges open, hold the door parallel to the appliance body
and screw the hinges to the door using suitable screws while taking
proper care.
11. Make sure that the door is properly aligned with the appliance body
(Fig. 9).
INSTALLATION OF THE
APPLIANCE
Installation of the appliance should be performed by a qualified install-
er. The appliance should be placed in furniture case (Fig. 10). Once
the appliance is placed correctly, adjust the height of the appliance by
turning the 4 adjustable feet as appropriate. If necessary, adjacent
appliances should be braced with a bracket fixed by screws and fitted in
furniture (Fig. 11). There is a special strip at the top of the appliance.
Attach it to the underside of the cabinet with appropriate screws sup-
plied with the assembly kit (Fig. 16). Decorative strip must not block
the vents located in the bottom casing unit, the strip must be cut to
size (Fig. 17). The depth of the bottom casing unit can be adjusted by
moving it forwards or backwards. Once properly adjusted, tighten the
mounting screws (located in the openings on both sides of the casing
unit) with a cross-head screwdriver. This will permanently attach the
casing unit (Fig. 18).
- 26 -
Publicité
