SEB BeerTender VB215700 Mode D'emploi page 16

8 Cleaning
In addition to routine cleaning, the BeerTender should be
cleaned after daily use and when you install a new
BeerTender Keg.
Warning! Do not dry the appliance and/or its
components in a microwave and/or conventional oven.
Cleaning after daily use
The drip tray and grate should be cleaned after every
use.
Remove the grate before emptying out the drip tray. The
grate must be set back in place during normal use of the
BeerTender.
note: You can wash the drip tray with warm water and a
mild detergent. The drip tray is also dishwasher safe.
Warning! Never use aggressive cleaning agents such as
vinegar, acids, solvents or petrol.
Cleaning after installation of a new Beertender Keg.
When you install a new BeerTender Keg you must clean
the dispensing spout. The spout is the only part of the
appliance that comes into contact with the beer.
It is essential to wash the spout either normally by hand
or in a dishwasher.
note: the dispensing spout comprises plastic and metal parts
that are permanently joined together and do not pose any
problems of hygiene. Do not attempt to separate these parts.
The beer dispensing mechanism must be cleaned using
a damp cloth and a mild detergent.
note: use a piece of cotton to thoroughly clean all the parts.
Warning! Do not attempt to clean the mechanism using
hard and/or sharp objects: it is a precision component
and you will risk damaging it.
16