Nordica MONOBLOCCO 800 ANGOLO Manuel Utilisateur page 33

MAINTENANCE AND CARE
AlwAys follow ThE INsTRuCTIoNs IN CoMplETE sAfETy!
Š Make sure that the power cord is unplugged (if present).
Š that the generator is cold all over.
Š the ashes are coMpletely cold.
Š ensure efficient air exchange in the rooM during the product cleaning operations.
Š poor cleaning will coMproMise correct operation and safety!
pERIoDIC ClEANINg uNDER usER's REspoNsIbIlITy
the periodic cleaning operations, as indicated in this use and maintenance manual, must be performed with the utmost care after reading the
instructions, procedures and frequency described in this use and maintenance manual.
check the external air intake, by cleaning it, at least once a year. the stack Must be regularly swept by the chiMney
sweeper.
let your chiMney sweeper in charge of your area check the regular installation of the device, the connection to the
stack and the aeration.
IMpoRTANT: ThE MAINTENANCE AND CARE MusT bE CARRIED ouT oNly AND EXClusIVEly wITh ColD DEVICE .
you should only use spare parts approved and supplied by la NoRDICA s.p.A. .
please contact your specialized retailer if you require spare parts. you MusT NoT MAKE ANy ChANgEs To ThE DEVICE!!!
glAss ClEANINg
after having checked that the door is completely shut (lowered), unlock the upper latch
then close the flap and lock the latch before lifting again the door.
thanks to a specific inlet of secondary air, the accumulation of dirty sediments on the glass-door is reduced with efficacy. nevertheless this can
never be avoided by using solid fuels ( particularly wet wood ) and it has not to be understood as a defect of the appliance.
IMpoRTANT: ThE ClEANINg of ThE sIghT glAss MusT bE CARRIED ouT oNly AND EXClusIVEly wITh ColD DEVICE
To AVoID ThE EXplosIoN of ThE sAME.
for the cleaning, it is possible to use specific products or a wet newspaper paper ball passed in the ash to rub it.
Do NoT usE CloThs, AbRAsIVE oR ChEMICAlly AggREssIVE pRoDuCTs by ClEANINg ThE hEARTh glAss.
the correct lighting phase, the use of proper quantities and types of fuels, the correct position of the secondary air regulator, enough draught
of the chimney-flue and the presence of combustion air are the essential elements for the optimal functioning of the appliance and for the
cleaning of the glass
bREAK of glAssEs: given that the glass-ceramic glasses resist up to a heat shock of 750°c, they are not subject to thermal
shocks. their break can be caused only by Mechanic shocks (bumps or violent closure of the door, etc.).
ThEREfoRE, ThEIR REplACEMENT Is NoT INCluDED IN ThE wARRANTy.
ClEANINg ouT ThE AshEs
all the devices are equipped with a hearth grating and an ash drawer for the collection of the ashes.
it is suggested to empty periodically the ash drawer and to avoid it fills completely in order not to overheat the grating. Moreover, it is
suggested to leave always 3-4 cm of ash in the hearth.
CAuTIoN: ThE AshEs REMoVED fRoM ThE hEARTh hAVE To bE sToRED IN A CoNTAINER MADE of fIRE-REsIsTANT
MATERIAl EquIppED wITh AN AIR-TIghT CoVER. ThE CoNTAINER hAs To bE plACED oN A fIRE-REsIsTANT flooR,
fAR fRoM flAMMAblE MATERIAls up To ThE swITChINg off AND CoMplETE CoolINg.
ClEANINg ThE fluE
the correct lighting phase, the use of proper quantities and types of fuels, the correct position of the secondary air regulator, enough draught
of the chimney-flue and the presence of combustion air are the essential elements for the optimal functioning of the appliance.
ThE DEVICE shoulD bE CoMplETEly ClEANED AT lEAsT oNCE A yEAR oR EVERy TIME IT Is A NEEDED (in case of bad working and
low yield). an excessive deposit of soot can cause problems in the discharge of smokes and fire in the flue.
ThE ClEANINg MusT bE CARRIED ouT EXClusIVEly wITh ColD EquIpMENT. this operation should be carried
out by a chiMney sweeper who can siMultaneously perforM an audit of the flue (checking of possible
deposits).
during the cleaning, it is necessary to remove the ash drawer, the grating, and the smoke deflectors from the device in order to ease the fall of
the soot. the deflectors can be easily extracted from their seats since they are not fastened using screws. once the clearing has been carried
out, place them back in their seats
CAuTIoN: ThE lACK of ThE DEflECToRs CAusEs A sTRoNg DEpREssIoN, wITh A Too fAsT CoMbusTIoN, AN
EXCEssIVE CoNsuMpTIoN of wooD wITh RElATED oVERhEATINg of ThE DEVICE.
12).
(Picture
(Picture 12
ENGLISH
pos. A), open the flap and clean the glass,
33 33